TweakHomePC

Dual-booting all versions of Windows and Linux

   Dual-Boot    |    Win 8    |    Win 7    |    Vista    |    Win XP/2K/NT    |    Win9x/Me    |    How to    |    Legacy 9x Tweaks    |    SiteMap   


 

Here: Home > Dual-Boot > Dual-Boot Windows 7 with other Operating Systems >


Install Dual-Boot of Windows 7 + Win2k (2000) on Windows 7 computer (Win7 installed first)

Last reviewed: June 2011

 

October 2013: This is the new location for this page on this site. Please update your link or bookmark.

Introduction

This guide shows how to correctly and safely create a natural dual-boot of Windows 7 and Windows 2000 (2K) on a computer with Windows 7 already installed. You can then run either of those two Windows by selecting one from a Windows menu during bootup. No data loss will occur and a third-party boot utility is not used.

In this procedure you need to shrink the Windows 7 drive to make room for Windows 2K unless you install 2K on a second hard disk. Using a second disk simplifies the procedure but it's not necessary. The example shown here uses a single hard disk.

32 and 64-bit versions of Windows 7 Home Basic, Enterprise and Ultimate were used in testing so this will also work with Windows 7 Premium and Professional. The operating system added was Windows 2000 Professional SP4. The computers used were (1) a 32-bit Dell Optiplex with Pentium 4 (2.26GHz), 2.0 GB RAM, 160 GB ATA hard disk, and (2) AMD Athlon 64-bit (2.4GHz), 2.0 GB RAM, 1 TB SATA hard disk.

Following these instructions correctly should always succeed. However, any change to your computer should not even be considered unless your have a rescue plan. This guide also contains that rescue plan - just in case!

This procedure is suitable for experienced computer users.


Important Installation Notes

Full Installation CD/DVDs. The Windows you are adding cannot be installed from Recovery or Repair CDs or DVDs provided by some OEMs. You need the full installation or setup version to install a Windows.

EasyBCD. The highly-acclaimed EasyBCD is a free editing utility that allows any user to easily edit the Windows 7/Vista boot menu (the BCD or Boot Configuration Data). Some settings, not used here, are very advanced. EasyBCD works in Windows 7 and Vista, but also in Windows XP if you first install Microsoft's .NET 2.0 Framework.

Hidden Active Partition. Many Windows 7 users will have a small Primary disk partition(s) that's marked active and is hidden (but is visible under Disk Management in Windows 7). This must be counted if you want to create a new Primary.

127 GB Partition Limitation in Windows 2K. Windows 2K setup files must be installed on the hard disk within 127 GB from the start of the disk. This physical limitation cannot be avoided. To play safe, all of the 2K partition should be within 127 GB from the start of the disk.

Shrinking a Windows 8, 7 or Vista drive. You should use Shrink in Windows' Disk Management to resize the Windows partition. You can read Shrink the Windows 8. 7 or Vista Partition for instructions on completing this task successfully. Use the free GParted Live CD to gain disk space only if you must - read the page Use GParted to Resize the Windows 8, 7 or Vista Partition to learn how.

Formatting. All partitions should be created before you start installing any operating system (OS). The partition should be Formatted when installing that OS to ensure compatible file system versions. Avoid formatting Windows partitions with GParted or any other third-party partitioning utility.

[top of page]

Details: Install Windows 2000 when Windows 7 is installed first

Installing other operating systems on your Windows 7 computer may invalidate your warrantee.

It's important to follow the instructions exactly as stated and you should start with a properly working Windows.


Make your preparations

  1. Backup important data before making any changes to a partition. You can burn files to a CD, clone an image of your hard disk, copy files to a USB flash/pen/thumb drive, or use an USB external drive (a good choice)
  2. Plan your new partitions carefully before you start.
  3. Download Neosmart's EasyBCD 2.1 (free - it edits Win7/Vista boot loader).
    Optional: Download NeoSmart's free Windows 7 System Recovery Disk if your Win7 DVD is missing!
  4. Download any essential device drivers for your older Windows.
  5. If you intend using a second hard disk, make sure that disk is in place before you start.
  6. Disconnect all unnecessary external devices before you start.

Make free space and create new partitions

This part is best completed BEFORE you start installing any other operating system.
Remember, you should never alter the starting position of a partition that contains an OS you wish to keep.

The single 160 GB disk usually used in testing initially had: System Reserved (100 MB, Primary, Hidden, NTFS), Windows 7 (150 GB, Primary, NTFS). The Windows 7 drive was shrunk leaving about 30 GB Unallocated space at the end of the disk (to the right). After repartitioning it had: System Reserved (100 MB, Primary, Hidden, NTFS), Win7 (110 GB, Primary, NTFS), 2K (5 GB, Primary, NTFS), Data (35 GB, Logical, NTFS).

Always note the size of each partition and also label each (this guide uses wn_7 and w_2K).
You can use a second hard disk for Windows 2K - the procedure will be similar to that described here.

  1. Restart computer correctly (close all programs before you Restart computer).
  2. Open Disk Management in Windows 7 (right-click Computer, select Manage, click Disk Management).
    • Right-click your CD/DVD drive(s), select Change drive letter and paths..., and click Change.
      Change the drive letter to K (get it out of the way!).
    • Right-click the Windows 7 Volume (probably C:), and select Properties.
      In the General tab, enter wn_7 as the label for the Windows 7 volume, and click Apply.
  3. In Disk Management in Windows 7
    • Right-click the wn_7 volume, and click Shrink Volume.
      • In Enter the amount of space to shrink in MB: enter enough for 2K
        (make sure the 2K partition starts before the 127 GB limit for that OS).
      • Click the Shrink button (it may take some time!).
      If Shrink does not give you sufficient Unallocated space, read how to Shrink the Windows 8, 7 or Windows Vista Partition for instructions or use the free GParted Live CD. Then return here.
    • Right-click the Unallocated space and select New Simple Volume.... Click Next.
      • In Simple volume size in MB:, enter about 5000 (5 GB for 2K). Click Next.
      • In File system, select NTFS in the drop-down.
      • In Volume label, enter w_2K.
      • Tick to enable the Perform a quick format check box, and click Next.
      • Click Finish button.
    • If you have a very large hard disk, you can create an extra NTFS partition for data.
      (Disk Management will automatically create Logical partitions when those become necessary).
  4. Restart to Windows 7.
    • Open Disk Management and check that the change made is correct.

[top of page]

Next Install Windows 2000 in this Windows 7 Dual-Boot

The link below shows how to install Windows 2K in this dual-boot and how to use EasyBCD 2.1 with it.

The Windows 7 boot menu will then boot Windows 7 or Windows 2000 when selected.

[top of page]

Related Reading

[top of page]

Please remember that you alone are responsible for the consequences of any changes you make to your computer hardware or software.

Copyright © LarryM 1998-2015 thpc@mail.com