Dual-booting all versions of Windows and Linux
Install Windows-controlled Dual-Boot of Ubuntu 13.10 (Saucy Salamander) on a Windows 7 computer
|October 2013: This is the new location for this renamed page on this site. Please update your link or bookmark.|
This guide shows how to leave Windows 7 unaltered when you create a natural dual-boot of Windows 7 and Linux Ubuntu 13.10 (Saucy Salamander) if Windows 7 is installed first. The Windows 7 boot loader will stay in control (not Linux's GRUB2). You can then select either OS from a Windows 7 menu during bootup. Basically you will still have a Windows 7 computer system that also allows you to boot to Ubuntu whenever you wish. No data loss will occur and a third-party boot utility is not used.
In this procedure you need to shrink the Windows 7 drive to make room for Linux unless you install Ubuntu of a second hard disk. Using a second disk is a little easier but far from essential.
All 32 and 64-bit versions of Windows 7 were used in testing. The computers used were:
(1) 64-bit Studio XPS 8100 (2.93 GHz), Core i7, 8 GB RAM DDR3, NVidia GeForce GTX 460, 2x1 TB SATA hard disks.
(2) 64-bit AMD Athlon (2.4GHz), 2.0 GB RAM, 128 MB Radeon XPress, 1 TB SATA hard disk.
Following these instructions correctly should always succeed. However, any change to your computer should not even be considered unless a rescue plan is available. This guide also contains that rescue plan - just in case!
The procedure used is suitable for experienced computer users.[top of page]
That's it! The Windows boot loader menu will boot either Linux Ubuntu 13.10 or Windows 7.
Details: Install Linux Ubuntu 13.10 on first or other hard disk when Windows 7 was installed first
Installing other operating systems on your Windows 7 computer may invalidate your warrantee.
Make your preparations
Make disk space available for Linux Ubuntu
You must create disk space and leave it as Unallocated. Decide first on how much disk space you need. Linux requires a minimum of two partitions - (1) Swap (Swap) and (2) Root (/) for Ubuntu files + boot files + all your data.
You may wish to create an extra EXT4 100MB minimum (10-30GB may be more reasonable) partition (/home) for your Linux data. This data partition can be left intact should you wish to upgrade or reinstall Linux at a later time.
The size of the Swap partition depends on the size of your memory (RAM) and your type of usage. With 2GB of RAM use about 4GB of Swap; with 4-8GB of RAM use about 6GB of Swap; with 16GB of RAM use about 8GB of Swap.
Make a note of the size of the Unallocated space when it's created.
If installing Ubuntu 13.10 on a 2nd or 3rd hard disk:
If installing Ubuntu 13.10 on the first hard disk:
Use the free GParted Live CD to gain adequate disk space only if you absolutely must - read the page Use GParted to Resize the Windows 7 or Vista Partition to learn how, and read Repair Windows 7 Startup (below) before you use GParted.
Install Linux Ubuntu 13.10 on a Windows 7 computer
No Raid or LVM was used when testing. Partitions were created manually during the installation. Ubuntu was installed on previously created Unallocated space with its boot loader installed to the Linux EXT4 / partition. Windows still booted automatically after Ubuntu installation. Finally EasyBCD was run in Windows to create the Ubuntu 13.10 entry in Windows 7's boot manager thereby creating the Windows-controlled dual-boot.
Place a Linux Ubuntu 13.10 boot option in Windows boot loader
Congratulations! You have created a natural dual-boot of Windows 7 and Linux Ubuntu 13.10 (Saucy Salamander) when Windows 7 was installed first, the original MBR is unchanged, and the Windows Boot Loader menu is shown on bootup.
Footnote: EasyBCD 2.2 creates an NST folder on the root of the Windows 7 partition when it adds an operating system to the Windows 7 boot loader. This NST folder contains boot sector file(s) vital to booting added OSs. It must not be deleted.
Older Computers with low maximum Screen Resolution
Ubuntu 13.10 itself runs fine at 1024x768 screen resolution. However GRUB2 may require a higher resolution (1280 x 1024) and users with old systems may be presented with a blank screen instead of the expected boot loader menu.
The boot menu is actually there but it's not visible! To run Ubuntu when the blank screen appears, just press Enter. To run Windows, press the down arrow key 4 times and press Enter. And then be patient for a few moments.
Remove/Uninstall Linux and reclaim space
Linux Ubuntu is wonderful, regularly updated, and it's free! Nevertheless you may wish to remove it or try its boot loader at some stage.
To try the Ubuntu GRUB2 boot loader
To remove Ubuntu and keep only Windows 7
Repair Windows 7 Startup
You will not have any problem if you follow the instructions as stated above. However you might encounter some freak occurrence like a power failure during an installation. Windows 7 will boot again if you execute the following procedure.
If still stuck for a solution, boot again from the installation DVD, select Repair your computer, highlight Windows 7, get to a Command Prompt, use DIR command (DIR C: or DIR D: etc.) to identify drive letter allocations (sizes and Labels will help), and type in:
Help! I get only the GRUB boot menu!
If you only get a GRUB boot menu on bootup, then GRUB was mistakenly installed to the Active partition, (hd0) - probably the Windows partition. The Windows boot loader has been overwritten by the Linux version but it's easily recovered.
How to reinstall/recover the Windows 7/Vista boot loader (BCD)
Please remember that you alone are responsible for the consequences of any changes you make to your computer hardware or software.
Copyright © LarryM 1998-2015 email@example.com